Precision extension- and
compression springs, flat spiral springs.
Wire bending and forming parts to drawing and samples.Materials:
Music wire to DIN 17223, Class C. No. 1.1200, BS 5216 ND 3 or HD 3, AMS 5112. Stainless
steel wire to DIN 17224, No. 1.4310, BS 2056 EN 58 A. Commercial 302 AMS 5688 spring
temper.
Coiled:
Right hand or left hand to drawing or user specification.
Ends:
Wire up to 0,8 mm squared and unground. Wire over 1,0 mm squared and ground. Extensions
springs German loops closed. End position will yary.
Loads:
Load values shown are for music wire and are based on a service life of 50 000 cycles at
0,50 stress range. For normal service springs should not be compressed below L1.
Tolerances:
All dimensions and forces to DIN 2095 / DIN 2097 (Grade 2).
Surface finish:
Normal wire oiled. Shot-peened and plated finishes supplied on request. Allow sufficient
additional time for special finishes. To determine the load at any working length use rate
x proposed deflection.
1 lb = 4,448 Newtons, 1 Newton = 0,225 lb. For compression springs with a higher spring
rate (P/f) see Heavy |
